Grinding table for surface grinding (KS)

Basically, you want a flat, clean surface for sealing surfaces. A grinding table for surface grinding is often sufficient as a grinding bench. EFCO offers the Grinding table for machine and fitting parts (KS) as a surface grinding table for fittings. This is a grinding table with a stop for safe guidance.

Depending on the size, wheels of up to 1000 mm are possible. Workpieces weighing up to 200 kg can also be loaded. Technically, this runs at 380 to 480 V. In addition, everything is ISO 9001 2015 documented and the Grinding table for machine and fitting parts (KS) is available for hire from EFCO Rental if required.

The Grinding table for machine and fitting parts (KS) typically machines flat workpieces with flat surfaces. You use the KS grinding table as a flat grinding table for quick reworking. This often involves a grinding table for fitting parts such as wedges, washers or plates. A surface grinding table can also be used as a grinding table for machine parts on sealing and contact surfaces.

In typical cases, it is also suitable as a grinding table for grinding valve wedges or as a grinding table for grinding valve discs. In addition, 600 mm wheels and 50 kg workpieces are common. Practical features include self-adhesive circular blanks, aluminum plates, foot switch and soft start. This makes the Grinding table for machine and fitting parts (KS) easy to plan in service operations.

Basically, the Grinding table for machine and fitting parts (KS) delivers a flatness that you control via the procedure and inspection. Pressure, grit and clean supports are decisive. As a workpiece grinding table, it runs like a stationary Grinding machine for flat surfaces.

This can be measured using a straight edge and feeler gauge, with a dial gauge if required. If the surface fits without a gap, the flatness is usually sufficient for repairs. In comparison, a face grinder offers more reserve for tight specifications. The Grinding table for machine and fitting parts (KS) gives you stable seating surfaces on fittings.

When in use, place the Grinding table for machine and fitting parts (KS) on a rigid, level surface. First check the support with a spirit level and align the adjustable feet. Then measure the axial run-out of the wheel using a dial gauge and magnetic base. Then set a reference point on the guide bracket and carry out a short test run.

When using the grinding table to grind valve disks, lay the part flat. Meanwhile, check the contact surface after a few strokes. This ensures that the Grinding table for machine and fitting parts (KS) runs smoothly and repeatably. The Grinding table for machine and fitting parts (KS) remains constant even when working in series.